Hi all,
Since i have not seen such a rendering before i would like to ask you for your support.
If you use Maxwell Render or Thea Render i would appreciate some tips and material set-up's
on how to properly archive a sub-surface laser engraved photo into a glass block.
Here's is my first humble approach with Thea:
Please note: The photo is inside the glass block and not mapped onto the outside.
If you like you can contribute also to the Thea Forum thread, which i started.
https://thearender.com/forum/viewtopic.php?f=148&t=21553
Best regards
Stefan
|