I"ll have to try it a bit later today though.

Basically the process is to extract the rounded piece using Edit > Separate, untrim it, then extract its seam edge, draw a line to extend that curve, join them together, use Rebuild to fuse it into one single longer curve segment, then revolve that to get a larger revolve surface.

- Michael

I have "wrong" edges on the other cuts as well. Next time, I will take care of this problem. Lesson learned ;-)

>>> Michael wrote "...making up that one testicle and..."

You're just not right ... :)

by the way, I don't think he wants to use the 'trim' command. It would be called the 'circumscribe' command in this case. I think Max should make a script.

OK, I'll stop with the potty humor..

:)

DS

Here's how I would fix this:

That's awesome! Thank you so much for your effort!!!

Know what? I saw the beginning of the youtube video before your posting was visible on the forum. Then I switched back to the forum and saw your posting :-)

Thanks Chipp, that's a good solution! And less painful without trimming any delicate areas too... :)

- Michael

And I thought this was a forum I could safely read while drinking my morning coffee. How does caffeine affect the anti-reflection coating on Apple displays? Anyone?