Made With MoI
 All  1-2  3-9

Previous
Next
 From:  chippwalters 5 Sep 2015  (3 of 9) 
7595.3 
Really nice! Thanks for sharing :-)

Have you seen MoI Interface Builder? OR
PAT the 3D Humanscale Model for MoI?
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson 5 Sep 2015  (4 of 9) 
7595.4 In reply to 7595.1 
Those are great pieces Alex, thanks for sharing the photos!

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  hep 6 Sep 2015  (5 of 9) 
7595.5 
Wow, very nice.
How did you ever cast those pieces from the print?
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  AlexPolo 6 Sep 2015  (6 of 9) 
7595.6 In reply to 7595.5 
The prints from the B9creator are UV set resin. Did a direct investment and burn from the 3d prints. I Burn to 850 degrees for a clean burnout. Good to cast after that.

https://www.b9c.com/

Hope that helps
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  hep 7 Sep 2015  (7 of 9) 
7595.7 In reply to 7595.6 
Thanks - i see. i have done similar with wax, but that melt at low temperatures (bigger parts though). But of cause the resin should burn as well.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Metin Seven (SEVENSHEAVEN) 7 Sep 2015  (8 of 9) 
7595.8 
Classy designs Alex. Did you use Flow for the rounded shapes?

———————

http://metinseven.com — 3D modeling • design • images
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  AlexPolo 7 Sep 2015  (9 of 9) 
7595.9 In reply to 7595.8 
Yep flat shapes generated to flow over basic 3d forms - great work flow.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-2  3-9