Hello everyone,

One of my edge appears to have multiple segments, which prevents the Fillet command to compile properly.

When I "Join" the segments, it creates a new, separate (detached) curve as oppose to fuse the segments from the original geometry.
The newly created curve was translated upward in image MOI_03.jpg to show it is separate.

Anyone aware of a command that will weld the segments together?

Thank you!

-J

Hi J, there is a Merge command that can glue together segmented edges into longer single edges if they are smooth to each other. Some info here:
http://moi3d.com/3.0/docs/moi_command_reference10.htm#merge

- Michael

That's exactly it. Thank you so much Mike!

-J

Thank you for asking and answering this as i too wondered about this, subscribing to the Forum RSS is paying dividends in my moi learning.