Full Version: Variable Width Line Offset Command - fatT Lines

Show messages:  1-8  9-28  29-48  49-51

Can be useful for architecture or other things! :)

Fat Lines support now multicolors : curves must disconnected and in different Planes!
By Michael! ;) https://moiscript.weebly.com/uploads/3/9/3/8/3938813/fatlines.v.0.7.2024.10.28.zip

If not you can make this little trick! ;)

Distribute your curves on Z http://moi3d.com/forum/index.php?webtag=MOI&msg=8503.17

Make Fat lines

Edit frame "Flat"

You can now Extrude your colored curves as you want!
And make any boolean operations!

All takes 3 seconds! ;)

---

hi pilou can you set the line widths to a specific width? e.g. 2mm or anything else a user may decide?

edit:
i presume that is setting the "larguer" slider shown in your earlier posts?

kindest...

---

Of course yes you can input any width !

Here 10 unities on 2 separated straigt lines
If you have several widths make several sets of lines (curves)



You will have a different result if you take connected lines! (here a polyline of 2 segments)

---

Show messages:  1-8  9-28  29-48  49-51