the real time commands
All  1  2-4

Previous
Next
 From:  andras
2682.2 In reply to 2682.1 
However It is not so important because I explored when I stay on command area (right side) the lines keep the positions.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
2682.3 In reply to 2682.1 
Hi andras, I think it would probably not be good to change it always to be a static command, because people who are working on a more typical amount of curves (like extruding only 2-3 curve at once) get a nice benefit from having the full feedback.

One thing that I have thought about doing is to switch the extrude into a lighter "wireframe" kind of feedback when the number of curves being handled was large.

Currently though if the mouse interaction is not going fast enough, you may want to enter in some numbers in the "Distance" input instead of using the mouse inside the viewport.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  andras
2682.4 In reply to 2682.3 
yes, yes of course
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1  2-4