Auto join option for offset?
All  1  2-4

Previous
Next
 From:  Michael Gibson
2543.2 In reply to 2543.1 
Hi Rob, yeah I'd like to put in something to do that.

One thing that has got me stopped up from doing that before was deciding whether to add that option in to Offset, or whether that should be added to the Shell command instead, as a way to "shell" a curve.

But even though it is kind of like shelling, it may just be easier to add it in to Offset since Shell does not currently do anything at all for curves, while Offset is all set up to handle curves already with all the various curve-specific options in there...

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  rhodesy
2543.3 
Yeah I would instinctively look in the offset dialogue rather than the shell one i think for that sort of command. I associate shelling with creating surfaces and offset with lines for some reason. Auto join would be a good tick box too.

Cheers for that although like you say you'd already thought about it!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  -ash-
2543.4 In reply to 2543.3 
I vote for this too. Hope you can squeeze this into V2.

Regards
Tony

(aka HamSoles)

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1  2-4