Fillet Radius 0

Next
 From:  Marc (TELLIER) 24 Jan 2008  (1 of 3) 
1305.1 
Hi!

I remember somewhere in this forum there was a topic about an equivalent to the "Fillet Radius 0" trick in Autocad to corner two lines.

I can seem to find the subject, Anybody has an idea?

Thanks,

Marc
Attachments:
AttachmentFillet Radius 0.png
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  tyglik 24 Jan 2008  (2 of 3) 
1305.2 In reply to 1305.1 
Hi Marc,

Just select both curves, run the Extend command and finish it by clicking Done button, righ-clicking of the mouse or by hitting Enter key...

Petr
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Marc (TELLIER) 24 Jan 2008  (3 of 3) 
1305.3 In reply to 1305.2 
That's it, thanks Petr!!!

Marc
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All