Show messages: All
1-3
4-6
From: Michael Gibson
Hi John, one thing that can help is for areas like this:
To get those pieces to connect well it can be good to have the surfaces extended so they push through each other by some amount rather than having their end curves just barely skimming on each other:
- Michael
Image Attachments:
john_extended1.jpg
john_extended2.jpg
From: Michael Gibson
Hi John, attached here is a cleaned up version that's all joined into a solid now.
I made the juncture area by having these extended surfaces to trim against each other. That's often a good method to make sure pieces will join cleanly.
- Michael
Attachments:
neck project2.3dm
Image Attachments:
john_extended3.jpg
john_extended4.jpg
john_extended5.jpg
john_extended6.jpg
From: jawiest (100BONNIE100)
Thanks I'll try it again.
Have a great day
John
Show messages: All
1-3
4-6