Show messages: All
1
2-5
From: Michael Gibson
Hi RIL, try this:
http://moi3d.com/forum/index.php?webtag=MOI&msg=10063.3
or this one:
http://moi3d.com/forum/index.php?webtag=MOI&msg=9439.13
- Michael
From: RIL
Yup, that did the trick.
Unfortunately only three tabs can be open at the same time on a 1920x1200 screen.
Perhaps it is possible to shrink the panels a bit, or lock them open (even if the lowest one then can slide out of screen, but then I can chose myself which other panel I would close to the the lowest one back in view again, aso). Now it just forcefully closes the lowest tab.
Edit: I tried also the jf-script in the *first link*, but that one allows only one of the two lowest panes to be open at the same time, either Construct or transform, so that one doesn't make any difference really.
// RIL
From: Michael Gibson
Hi RIL, it is possible to shrink the panels (and all of the UI) down a little bit by using Options > General > "UI size". Move the slider a little to the left and all the UI will shrink down.
> Now it just forcefully closes the lowest tab
Yes, it's intentionally designed to behave like that. Trying to make an individually lockable setup would be pretty complicated.
- Michael
From: RIL
> Options > General > "UI size". Move the slider a little to the left and all the UI will shrink down.
Perfect! Moreover, if first shrinking until enough panels show, then one can increase again and they stay expanded.
Thanks!
// RIL
Show messages: All
1
2-5