Hi Pilou,

> If you design the 2 pieces in meters then at the end make a scale / 100
> Does you obtain the same result than in mm ?
> Does Moi's functions will be helped?

You could do something like that - if you switch the unit system in Moi it will apply a scale for you.

But anyway in this particular case any scaling should not be necessary, I think it's just a matter of luck that the different scaled version did not happen to run into the uv trim curve bug.

With this next upcoming release that particular bug should be fixed. Hopefully there are not too many new ones introduced, we'll see!

- Michael