Hi isaac, I checked out your vid.

> Starts off just like you did but then all the steps after
> entering the height were inferencing perpendicular/parallel
> or lengths by hovering over existing lines no grid snap only
> point snap and inferencing

I guess I'm not quite understanding, this is the same result (wireframe anyway) as I showed previously right? (shown here).

You do it in SketchUp by using point snap and inferencing.

You do it in MoI by using point snap and construction lines.

If the result is the same, I just don't really follow what the problem is - use the construction lines in MoI to get that result and you will have what you want, right?

You can use construction lines in MoI to do all that kind of stuff that inferences lets you do in SketchUp.


Also, following your video there is one line segment that is shooting out too far, there doesn't seem to be a way to get that one aligned to the intersection from 2 from-edge perpendiculars in SketchUp. If you notice in the screencap I showed above doing it in MoI, every single point was precisely snapped into place without any overshoot anywhere...


Do you need me to go more step-by-step to show how to use the Clines to do the kind of stuff you want to do?

- Michael