Planar surface command

Next
 From:  mk (MARKY)
10000.1 
Once in a while I'm not able to get a planar surface from the curve, an example attached.
Any solution, please?



Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Frenchy Pilou (PILOU)
10000.2 In reply to 10000.1 
If you call Show Points you will see that several Control Points are in a red square color!

That means that for any reason some are overlaped!

So redraw / Edit the curves or erase some control points...

A speedy process is select the curve(s) than Press Tab then write "Rebuild" ! ;)
(or REbuild rebuilD rebuild... etc but without spaces ;)
you can of course make a shortCut putting Rebuild in the second column !

EDITED: 20 Oct 12:08 by PILOU

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  WN
10000.3 
It is easier to export to PDF, AI or EPS and then import from there.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All