Hi Michael,

With the body designed from three profiles and a guide line, one leg is longer than the guide line indicates.
Could you please tell me what I doing wrong?

Regards
Bodo-Lutz

Hi Bodo-Lutz, I'm a little puzzled by the strange result but it seems to have something to do with these small line segments at the ends of the guide lines:



Try the attached version, here I removed those segments and stretched out the last control point of the next segments.

Also I noticed the 3 profiles were not closed curves, they have a slight gap here:





I closed those up by using Transform > Move on the upper point to move it down. I'll have to investigate the weird result, seems like a bug.

- Michael

Hi Michael,
thanks for your quick help.
Before I've experimented a lot. I tried to cut off the body overlength, but impossible.
Unfortunately I hadn't found the missing 0.016 mm line in profile.
However, it would have been displayed with a test using the planar function. Next time I will do this.

Bodo-Lutz