Hello

I've been asked by my school to print covid Protection.

I print tests on whitebox 2 and now I would like to create objet stack. If I let a few space between objets, they get stuck

Any advice is welcome.

Thanks in advance.

Regards

Hi Gwozik, looks like a little bit of discussion here:

https://3dprinting.stackexchange.com/questions/860/printing-multiple-prints-stacked-on-top-of-each-other
https://3dverkstan.se/protective-visor/faceshield-faq/


And you might check out these to see if there are any ideas that you could use:

https://www.myminifactory.com/object/3d-print-a-better-and-faster-stackeable-visor-faceshield-116968
https://www.prusaprinters.org/prints/27267


- Michael

Thank you :)

Popularised in France by Heliox
You can put subtitles ;)

I have designed this visor in moi for 3d printing on my machine. I can get 80 on my print tray, by leaving a small gap in between them so that the printer software fills it with a minimal layer of support. In reality after running this file once I found it more convenient to run 4 or 6 at a time. I have attached my nested file incase anyone would like to use it. If any on wants the visor shield info please ask!

James Elliott

Thanks :)