Flow inconsistency

Next
 From:  Finema
8765.1 
Hi,
I just copy the cone, move it and apply the same Flow as on the previous one.
The result are differents. The first is OK but the copied cone is not ok.
Can you explain ?
Thanks
Attachments:

Image Attachments:
Size: 683.4 KB, Downloaded: 41 times, Dimensions: 3264x2228px
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
8765.2 In reply to 8765.1 
Hi Finema, the location that you pick on both the base surface and the target surface is significant in Flow and you're probably picking in a spot that is not clear enough to make it consistent.

You need to pick inside of an edge, towards one end but not all the way in the corner. That will control any flipping or rotation of the UV space to match your pick points.

So for your case here you'd want to pick on the blue dot spots for example when selecting the base and target surfaces:



It needs to be able to identify which edge you're closest to and also which side of that edge you are closest to. Right in the corner isn't good because you're not controlling which edge will be targeted for the match.

- Michael

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Finema
8765.3 In reply to 8765.2 
Hi Michael
yes i was picking all the way in the corner...
Thank you very much for your efficiency
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All