Hi all, I've been watching a tut on Youtube called "Moi3D hard surface" and have been following along but have run into a wall. What am I doing wrong? I'm trying round off the corners. He used the fillet tool which doesn't work for me yet I would have the the chamfer tool would be better to use. In any case that didn't work either. If I'm missing something please let me know.

Cheers

Hello,

I think the grid is set at 1mm right, so your smallest edge in the drawing is 1 mm. Try a fillet value smaller than 0.5 mm (0.4 mm should work).

Hello,

it seems that the fillet is to big. Try to make the fillets one for one. Check if the radius of the fillet is not bigger than the shortest line.

Good luck
Karsten

Thanks for the reply, It seems to be working now after closing and opening Moi again. I used .5 fillet on this. Strange. I appreciate your feedback, thx!