Extrusion

Next
 From:  Bill (WM)
8555.1 
Hi Michael,

I was wondering if it would be possible to have a selection button to Cap Ends when doing Extrude-Tapered?
Similar to Extrude-To Point.

Just a suggestion, perhaps something to think about for Version 4.

Regards,
William
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
8555.2 In reply to 8555.1 
Hi William, unfortunately the geometry library did not have an option for not capping the ends of tapered extrusion, that's why there isn't an option for it in MoI's UI either. I think it should be possible for me to modify it so that would work though.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Bill (WM)
8555.3 
Michael,

Thanks.

Regards,
William
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All