Flow a circular (flat) pattern on to partial sphere
 All  1  2-5

Previous
Next
 From:  Frenchy Pilou (PILOU) 7 Dec 2015  (2 of 5) 
7760.2 In reply to 7760.1 
It's the same problem than in this video! ;)

You must first "Flat" the surface for draw your lines on it!

EDITED: 7 Dec 2015 by PILOU
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Duane (CANADADUANE) 7 Dec 2015  (3 of 5) 
7760.3 In reply to 7760.2 
Whoa. Where does that power menu with ShrinkTrimmedSrf come from?
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  danperk (SBEECH) 7 Dec 2015  (4 of 5) 
7760.4 
Make sure that you use ShrinkTrimmedSrf on your partial sphere and flatten a copy for your base surface.



Example file attached.
Attachments:
AttachmentFlSph.3dm
AttachmentFltSph.png
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Duane (CANADADUANE) 7 Dec 2015  (5 of 5) 
7760.5 
Well, that was a little more frustrating than I'd hoped, but now that I know I can type commands in to the console by pressing Tab, I guess I have a way forward. Thank you all who led me in the right direction!

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1  2-5