bleeding mesh edges and exporting UV's
All  1-6  7-9

Previous
Next
 From:  Michael Gibson
772.7 In reply to 772.6 
> Do you mean you can cull the backfaces of the meshes
> on solid objects only? That sounds good enough for me.

Yup, that's what I meant. I'll try to take a look at it tomorrow, it is probably not too hard.


> But if i ever see it again and if it proves to be not-me related, then i will send a file to you.

Sounds good, thanks!

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
772.8 In reply to 772.6 
Hi Jonah, this is tuned up with the new beta that's just out now. Now backfacing edges are culled for solids, so that should generally avoid the bleed-through issue for those cases.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  jbshorty
772.9 In reply to 772.8 
Thanks Michael :)

jonah

EDITED: 26 Jul 2007 by JBSHORTY

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-6  7-9