Starting with MOI and adding Rhino later
 All  1  2-4

Previous
Next
 From:  3dcnc 10 Apr 2015  (2 of 4) 
7341.2 In reply to 7341.1 
Yes, using Moi first will speed up your rhino learning. It won't be a waste learning Moi first. I teach students this way.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson 10 Apr 2015  (3 of 4) 
7341.3 In reply to 7341.1 
Hi Jack, yes that can be a good way to get going, MoI is easier to start with.

> Are the two interfaces similar, etc.

The interfaces are a little different but the overall strategies for how you construct things are similar and so a lot of what you learn about how to construct things will be applicable between them.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Frenchy Pilou (PILOU) 11 Apr 2015  (4 of 4) 
7341.4 
CTRL + C, CTRL + V between the 2 applications in the 2 ways ! ;)
---
Pilou
Is beautiful that please without concept!
My Gallery
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1  2-4