2D scale
 All  1-6  7-8

Previous
Next
 From:  Michael Gibson 25 Nov 2014  (7 of 8) 
7080.7 In reply to 7080.6 
Hi Andrei, so for a case like that you can use the View > CPlane tool to set the cplane onto the flat cap of the cylinder, then when you do the Scale2D it will happen in that plane.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Andrei Samardac 25 Nov 2014  (8 of 8) 
7080.8 In reply to 7080.7 
Yes I made it everytime when I whanted to scale 2D but used edit frame+shift. Just wanted to try this tool and was a bit confused.

____________________________________________________________________
My Portfolio: www.samardac.com
A lot of my Tutorials!
Subscribe to my youtube channel: http://www.youtube.com/samardac
Russian community of MOI 3D: www.vk.com/moi3d
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-6  7-8