Hello PaQ,

Upon initial investigation it looks like you just have six small areas to clean up. I doubt you'll need to recreate the model.

I managed to extract one of them, and it's a little tiny 4 point curve with all the points stacked up on top of each other, it makes it think it's a closed curve...

Probably the pieces will need to be untrimmed and retrimmed to get rid of these.

- Michael

Yeah only the 4 surfaces around each of those pink dots that show above will need to be extracted, untrimmed, and retrimmed. And some of the surfaces have natural boundaries and so don't need to be retrimmed. I'll see about cleaning it up for you.

- Michael

Here's the bigger part fixed up.

And inside part fixed here.

- Michael

Thank you very much Michael, I now need to understand how I manage to create this strange little close curves :S

and ... thanks again for the quick user's mistake support !

Greeting from little Panda :)

Hi PaQ,

> Thank you very much Michael, I now need to understand how I manage to
> create this strange little close curves :S

You're welcome! It's likely that they are some side effect from an intersection bug but it's difficult to track it down after the fact...

Panda looks great!

- Michael