Works cool!
But U+V must be made in 2 pass ! (we have the Menu U+V , U, V visible)
Does this normal ?

Hi Pilou,

> But U+V must be made in 2 pass ! (we have the Menu U+V , U, V visible)
> Does this normal ?

It depends on the surface you're using it on - but yes often the edge that you select as the generator will be running in the U or V direction and in that case only the opposite one will work with that edge. You would then need to select an edge in the other direction to make the other set.

- Michael

Ok Not a big deal ! ;)
so French version will be enable in few time! :)
Done!
http://moiscript.weebly.com/multiiso.html

I just keep - Both. But, yes I think direction menu have no need.

Some tutor on how to use MultiIso and DistortCurves scripts to make tree:

Cool use of the distord curves!

Wow, love these scripts! MultiIso, DistortCurves and Randomize offer a lot of power to get rid of order and smoothness, when desired.

This is a "turbo" version of Michael's MultiIso script :)

Seems don't work on a box! ??
Only menu appears : Select Source Edges then nothing!

Works fine on a deformed sphere 3D!

Original MultiIso does not do box either, unles Separated.

- Brian

TurboIso has only U direction?

is there a difference between MultiIso+/MultiIso Scripts and the _cMorph Script? Because I did get errors if I run MultiIso+, but no problems with the _cMorph script. And I see they are similar, or they aren't?

They are totally different!

Cmorh draw only from one curve to another one curve ! Surfaces are not taken in compt!
Of course at the end you can make a Loft if you want! :)



CMorph don't work with angles curves!!!



Lineweb can also help you in certain cases! (angles curves)



MultiIso + draw curves on surfaces (volumes)! ;)