Fillet trouble on converging edges
All
1-17
18-19
From:
OSTexo
4 Feb 2014 (18 of 19)
6479.18
Hello,
The back edges of the original model are not fitting too well, rebuilding the base model from scratch leaves a better end result.
Attachments:
backcorner.png
Reply
More
Post Options
Reply as PM
Print
Mark as unread
Relationship
IP
Logged
From:
Andrei Samardac
5 Feb 2014 (19 of 19)
6479.19
Good, understood.
I made new tutorial about Collapsing fillet (disappearing fillet). You can check it here:
http://moi3d.com/forum/index.php?webtag=MOI&msg=6058.30
-----------------------------------------
My Portfolio:
www.samardac.tumblr.com
-----------------------------------------
A lot of my
Tutorials
!
-----------------------------------------
Russian community of MOI 3D:
www.vk.com/moi3d
Reply
More
Post Options
Reply as PM
Print
Mark as unread
Relationship
IP
Logged
Reply to All
Show messages:
All
1-17
18-19