Silly question All  1-6  7-8

Previous
Next
 From:  Frenchy Pilou (PILOU)
64.7 In reply to 64.6 
< Straight snap must be enabled
It was not ! Haaaaaaaaaaaa!

I suppose that is not possible to keep the guides lines for a next tool drawing?
(a sort of layer of guides lines)

Thx for all your precisions
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
64.8 In reply to 64.7 
> I suppose that is not possible to keep the guides lines for a next tool drawing?

No, not yet. I have thought about having some button that would make them stick around, but then there would have to be some mechanism to allow you to select them or remove them later and I haven't spent any time to figure that part out yet.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-6  7-8