Where is the flow command?

Next
 From:  Bo (BOHUNTER11)
5828.1 
I can't find the Flow command. There is no deform or flow command.
I'm using the trail version, is it missing from it? I'm following a tut that
uses the flow command and was wondering if it's been removed.

Thank You,
Bo Hunter
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  futagoza (STEFAN)
5828.2 In reply to 5828.1 
Hi Bo,

you should find it under the Transform menu.

Regards
Stefan
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  futagoza (STEFAN)
5828.3 In reply to 5828.2 
...well, at least in the 2.52 OSX trial vers. of MoI.

Regards
Stefan
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
5828.4 In reply to 5828.1 
Hi Bo, the Flow command is new for version 3.0 so it's not available in the v2.0 trial which must be what you're using. It hasn't been removed - v2.0 just predates its existence.

Once v3 is released there will then be a new trial version out for that which will then have the new Flow command in it, that's still a little ways away though.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All