Question about Tapered Extrude.
All  1-2  3

Previous
 From:  blowlamp
5554.3 In reply to 5554.2 
Michael.

Thanks for taking the time to answer this question - I can see it's not an easy thing to automate.
However, with a few sweeps, followed by use of the Trim tool and then a little deleting of unneeded surfaces, I've managed to get a very acceptable result from MoI :-) So I'm happy it can be done.


Thanks again.
Martin (2).



EDITED: 18 Nov 2012 by BLOWLAMP


  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-2  3