Thank you Jesse.
I will post in this thread my questions.
I will post some JPG sketched by hand also to get to my point....
I am a slow learner, therefore I have to really learn one step at the time, like a child is learning to walk.
Rudy
Sounds good..post your models and ask questions...there are many people who have a lot to offer on this forum...and check out some of the other
tutorials, even if they're not for jewelry, everything you learn will apply. I posted some step by step examples and variations of the ring model in my previous post.
I too have been struggling to learn Rhino for jewellery & have found Moi much easier to learn.
I'd been using the Rhino Jewellery Tutorials from CadWax to start learning in Rhino3, they where free at the time. http://www.cadwax.com/default.htm
I then found that I could use most of these instructions for designing jewellery in Moi.
There's some specific tools & things that only apply to Rhino, but it does give you a good starting point.