"Corner point" toggle: key shortcut?
All  1  2-5

Previous
Next
 From:  BurrMan
5244.2 In reply to 5244.1 
Ctrl+ key.....
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
5244.3 In reply to 5244.1 
Hi Jacbob, yup like Burr mentions hold down the Ctrl key while you are clicking, it will have the same effect as turning on the "Make corner point" checkbox just for that one pick and releasing it will allow non corner points to be placed.

You won't see the checkbox go on or off while using it, it's just a separate shortcut for doing it.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Jacob
5244.4 
Doh! I can't believe I haven't found it out yet, even by accident!

Thank you!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Fake Pilot (FAKEPILOT)
5244.5 
This is awesome... Could skip Line and Polyline tool and just use Curve tool for everything. Ctrl clicking when needed... :-)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1  2-5