Custom shape for bevel?

Next
 From:  artisanicview
5085.1 
Hello. I want to make a front door for a furniture and I need to apply a custom bevel to the exterior edge of the profile but I can't figure out how to do. I tried all the tools MoI have but I just can't figureout how to do. Please help.
Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  artisanicview
5085.2 In reply to 5085.1 
P.S. It seems that I can't post? I tried to post and my post was not posted in forum.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  BurrMan
5085.3 In reply to 5085.2 
Be sure you are viewing all discussions..



You'll get used to it...

EDITED: 19 Jun 2012 by BURRMAN

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  BurrMan
5085.4 In reply to 5085.1 
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
5085.5 In reply to 5085.1 
Hi artisanicview, by default the forum will have that drop-down that Burr shows above set to show only discussion threads that have posts in them that you have not read yet.

But if you switch it to show all discussions like Burr shows there, then you would have seen your post.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All