Geometric continuity...

Next
 From:  tyglik 28 Mar 2007  (1 of 2) 
506.1 
Hi Michael,

Just one question related to V2. Are you going to add an options for ensuring geometric continuity to neighbouring surfaces for Sweep, Loft or NetworkSrf commands in case the edges of adjacent surfaces are selected instead of stand-alone curves?

Petr
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson 28 Mar 2007  (2 of 2) 
506.2 In reply to 506.1 
Hi Petr, yup I would like to attempt to do this for V2.

But I'm not quite sure yet how well the geometry library that I'm using supports this.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All