3d Shrink Command (3d Offset)
 All  1-4  5-7

Previous
Next
 From:  NightCabbage 29 Feb 2012  (5 of 7) 
4974.5 
Hey Michael

Thanks for the tip! That looks a bit easier than my current method!

I'd still really love a command for this type of operation though ;)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Andrei Samardac 2 Jan 2013  (6 of 7) 
4974.6 In reply to 4974.3 

Hi Michael, about Inset comand.
Moi do not allow to set thikness to zero in "Use separate height" mode.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson 2 Jan 2013  (7 of 7) 
4974.7 In reply to 4974.6 
Hi mir4ea, the Inset command is basically set up to generate a shape that has a border around it - if you want something with a 0 border width that would then be just a regular offset, use Offset or Shell for doing something like that rather than Inset.

Some previous discussion here:
http://moi3d.com/forum/index.php?webtag=MOI&msg=5508.11

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-4  5-7