faint lines...
All  1-3  4-5

Previous
Next
 From:  Michael Gibson
4896.4 In reply to 4896.3 
Hi niko - the easiest thing is to not worry about it - if you are manufacturing this part there is no way that tiny level of detail is going to make it into the end result.

Otherwise if you want to get a smooth result between pieces you need to use Fillet or Blend to generate continuous surfaces, other techniques won't work.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
4896.5 In reply to 4896.3 
Or also you might want to use Rhino and try the MatchSrf command in Rhino which is an editing tool that adjusts an untrimmed edge of one surface to be smooth with another. It could help you in this kind of situation.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-3  4-5