Hi Michael ...
Yes, the mutual extend command would be great and I know you would streamline it well.
And, yes, the boolean trim would be very helpful.

Now that I have set up a big set of appropriate styles I am now doing the bulk of my 2d drafting with MoI and all my modeling ... though I have other programs immediately available on my system.

The line selection works well ... I was just not using it optimally. I had incorrectly assumed I had to choose with each use and for some reason I automatically clicked on line rather than polyline unless I paid close attention. As I use polylines most of the time by choice I just have to pay a little more attention until it becomes my auto choice.

Do you have a timeline for the next beta release?

Thanks,
eric

Hi eric,

> Do you have a timeline for the next beta release?

Well, I'm still in the process right now of wrapping up the Mac version, but that's getting close to being done.

Once that is wrapped up then I'll be returning back to working on new v3 features, my guess is that would start to happen again in February.

- Michael