What do I have to do to get a clean surface from the network command in MOI? Please help....
 All  1-7  8-9

Previous
Next
 From:  Michael Gibson 13 Jan 2012  (8 of 9) 
4847.8 In reply to 4847.7 
Hi niko,

> The problem with this is that the seam in the middle is quite visible...

If you leave some space between the pieces you could then use the Blend command to build a smooth connector piece between them.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  niko (NICKP100) 13 Jan 2012  (9 of 9) 
4847.9 In reply to 4847.6 
yeah that was my beef with MOI......in one of my previous posts Michael said that he'll work on the network command in V3 to make it more like Rhino..
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-7  8-9