Pillow Script, request for method to put end points on factory curves.
All  1-5  6-10

Previous
Next
 From:  Michael Gibson
4512.6 In reply to 4512.5 
Hi Brian,

> Used "interpcurve" curve type, which I believe is Through
> the points, versus "curve" type.

Yup, that's correct.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  bemfarmer
4512.7 
Thank You.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Frenchy Pilou (PILOU)
4512.8 

EDITED: 24 Sep 2015 by PILOU

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  bemfarmer
4512.9 In reply to 4512.8 
How about "mark curve start"
Flip
"mark curve start"
?

- Brian
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  bemfarmer
4512.10 In reply to 4512.8 
I'll have to look at this again, for the points.
Amazingly, its been 4 years!
Some learning has occurred meanwhile :-)

- Brian
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-5  6-10