Hi BurrMan,

Here is what I have shown as default for Mesh Angle:





Have a Happy New Year!

Michael T.

Yup 10 degrees is the default. You can go coarser (larger angle value like say 25 degrees) than that to reduce memory consumption on large models, but it's not too good to go with any lower angle than 10, that already makes a pretty dense mesh by default.

- Michael

Thanks Michael and Michael! I've been running 4. I dont rmember when I lowered it, I think I did when I was analyzing some bad geometry and was looking for gaps and bad trims and such....Forgot to put it back.

Happy New Year!

Happy New Year, Burr!

Yeah one area where the display mesher can currently be a bit too sparse is when a shape is kind of large but only shallowly curved. Breaking things down by angular deviation alone doesn't really give enough detail in those kinds of situations and that leads to some jaggies in the display.

In v3 I want to try adding in another method to refine the display mesh in addition to the angle deviation that should help give more detail on those kinds of shapes.

- Michael