extrude command

Next
 From:  andras
2998.1 
Hello!

There are some problem with extrude command in this case... it dont works.
I would like to extude the faces but actually all the same the polylines dont work as well.
threre is no cap of final result.
Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  BurrMan
2998.2 In reply to 2998.1 
Hi Andras,
Your points are not touching in this area. If you turn on control points for these 2 entities and then window select that corner point (Actually 2 points):



Then switch to the right view and hit the reset view icon you will see this:




Go back to the 3d view and select the little vertical lines bottom point and snap it to the horizontal end point and it will extrude as solid.

EDITED: 19 Jun 2012 by BURRMAN

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson
2998.3 In reply to 2998.1 
Hi andras, looks like Burr has you covered here, thanks Burr!

Usually if an extrusion will not cap it means either the curve was not planar, or not closed, or it possibly has a self intersection (crosses over itself) in it somewhere.

Please let me know if you need any more help with this one.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  andras
2998.4 
thanks guys everything ok
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All