Thanks Michael,

I've gone back to the Nov-21 beta for the time being as that doesn't seem to have the problem.

Will you be able to have another beta out before the Nov-21 one expires on Feb 21?

Hi Tony,

> I've gone back to the Nov-21 beta for the time being
> as that doesn't seem to have the problem.

It has the same problem only in the display mesh, but not the export mesh.


> Will you be able to have another beta out before the
> Nov-21 one expires on Feb 21?

I think so.


- Michael

Thanks Michael,

>>It has the same problem only in the display mesh, but not the export mesh

Yes, I noticed that, but the target is modo so it's the export I was needing.


>> I think so.

I hope so :-)

Though, is the export mesher in V1.0 the same as that in the Nov-21 beta. Could I model in the Jan beta then open and export from V1?

Hi Tony,

> Though, is the export mesher in V1.0 the same as that
> in the Nov-21 beta.

It's almost the same, just a couple of bug fixes are the only difference such as the "Avoid smaller than" setting did not work completely properly in v1.


> Could I model in the Jan beta then open and export from V1?

Yeah I think that would most likely work.

- Michael

>> Yeah I think that would most likely work.

Cheers, still hopeful for a new one first :-)