Continuous surface
All  1-13  14-17

Previous
Next
 From:  BurrMan
2237.14 In reply to 2237.13 
Sorry. I just noticed your talkin about your "particular" curves. My bad.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Message 2237.15 deleted 11 Dec 2008 by BODINI

Previous
Next
 From:  Nick (BODINI)
2237.16 
Ack, this one broke flat sweep. Extrude path worked. Better stop now. :)
Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Frenchy Pilou (PILOU)
2237.17 
In fact seems nature of curves, & orientation are very sensitive!
this one works fine with Network! (5 seconds on a very old comput)
A small change and all works fine or not!
So a big training is necessary :)

Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-13  14-17