Michael,
How did you move the center point of the rotate widget. I'm stuck here. It looks like you drag it but i drag the whole object.
Burr

I'm sorry I got it, Ckick and let go! It's not a drag.

Thanks,
Burr

[EDIT]
WOOOOOOW!
[EDIT]

Hi Burr - yup, click and let go on the rotate grip initially to switch to "wheel mode".

Once you are in wheel mode then that center point stays on and you can go grab it and reposition it.

While in wheel mode dragging on a wheel will do a rotation, and clicking somewhere out off of a wheel exits the mode.

- Michael

Hi Michael, thanks a lot for the script, quite handy ... but do not waste to much of your time in this.
It's still takes me to much time, whatever the method : the tangant construction line method, or the circle along curve one.

At the end, it takes the same time (or even more) than using the standard method, and editing every control by hand to adjust the rope intersection.

Great discussion, guys. I've been using LWCAD v3 to assist with my similar piping needs. That's means I have to depend on getting my models into LW (cleanly) to continue my work...

Anything to assist with these piping tasks within MOI is certain appreciated!

-Will

Well the job Im working is also rendering with lightwave :P ... a bit to late to learn/use/buy for lwcad too :(

I wish a could place 100 of them, but I will not have the time ->

I was wondering how come and you spot all the bugs in MoI, now I know, eager to see it finished...