Sweep ignoring corners?
All  1-4  5-8

Previous
Next
 From:  Nick (BODINI)
2183.5 In reply to 2183.1 
Offset the centerline of your sweep to the inside (so there are 2 lines). Then use those 2 rails for the sweep to get mitered corners.

EDITED: 27 Nov 2008 by BODINI

Image Attachments:
Size: 104.1 KB, Downloaded: 66 times, Dimensions: 729x481px
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  WillBellJr
2183.6 
Yes this one has urk'd me in the past also!

But as already mentioned, a 2-rail sweep will get you what you originally expected.

I didn't know about the micro bevel getting this to work as well?!

-Will
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  duke
2183.7 
The 2 rail option seems to be the best. The micro fillet forces the sweep to turn a corner, but it's not a clean result - it goes through itself.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  BurrMan
2183.8 In reply to 2183.7 
Also not mitered as I think that was the intended result.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-4  5-8