Nectaris S-61 'Bison' Tank
 All  1-10  11-12

Previous
Next
 From:  Yenmonger (OTTERMAN) 13 Dec 2008  (11 of 12) 
2122.11 
Here's the result of using GrowIt to make the 3D print. Their resolution wasn't as good as I hoped, so for now on I'm going to continue using Todd Boyce / NinjaMagic.

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Crusoe the Painter (CRUSOE) 29 Dec 2008  (12 of 12) 
2122.12 In reply to 2122.11 
You can also try printapart.com. Not as fine a finish as NinjaMagics machine, but the prints are more durable, and the detail IS sharper than the Objet. What layering there is, covers fine with primer/paint.

I as well, have been disappointed with the objet finish. The details seem to 'melt' a bit.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-10  11-12