Works great, Thanks!!!

Radius / diameter in functions like Circle?

Yes, like in circle, I kept making my designs using radius when I wanted diameter :)
Tom

Hi Pilou,

> Radius / diameter in functions like Circle?

Yup, this controls the default used in several radial-type commands such as Circle, Sphere, Cylinder, Cone, also one variety of Arc.

Currently you can switch these commands to use a diameter value by clicking on the "Radius" label, there is a kind of little "cycle" arrow on it.

Normally it defaults to Radius, this change allows you to set the default to Diameter instead.

- Michael

OK ;)

I will find this tweak useful also!

Marc