Very nice model. I was asking in another thread recently about the best way to get that thin groove where the two halves of a plastic case meet. Can I ask what method you used for that? Did you cut it out with a boolean, as Michael recommended I do?

Oh, and Moi is fun isn't it? I keep wanting to fire it up and try new things.

Thanks for the comments.

Yep - just cut it straight in half and added the chamfer, mirror and stuck back together.

Nice model but...
Continue to read only if you are interested to increment realism.

1 - the depth of the object is too large
2 - the SCART flange is a metal sheet folded and therefore can not have these angles
3 - the SCART pins are TOO large! ;-)
4 - PIN jacks looks strange: the colors are inside the inner contact and the shield is not curved on top.

Ciao

Thanks for the comments - I had not noticed "2" and I don't know enough Modo to see where the colour in "4" went wrong :).

I've started to play with a better version and will definatly take your comments into account, thanks.

Another try.