Add "Make corner point" as a shortcut key?

Next
 From:  BEANZVISION 29 Jan  (1 of 5) 
11915.1 


Hi guys, I use the "Make Corner Point" setting a lot and wanted to add it to a shortcut key. What should I be putting here as I can't figure it out. Many thanks!
Attachments:
Attachmentcornerpoint.jpg
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Frenchy Pilou (PILOU) 29 Jan  (2 of 5) 
11915.2 In reply to 11915.1 
Press CTRL when you click a point ! You win a shortCut!

For avoid to recall the fonction Curve , enable repeat case...
For close the function press Right Click, Right Click again for recall the function if repeat is not enabled!

EDITED: 29 Jan by PILOU
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  BEANZVISION 29 Jan  (3 of 5) 
11915.3 In reply to 11915.2 
Oh my god! You sir are a legend! Thank you so much :)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Mik (MIKULAS) 29 Jan  (4 of 5) 
11915.4 In reply to 11915.3 
Many "hidden secrets" can be found at https://moi3d.com/4.0/docs/moi_command_reference.htm
Hope this helps.
Mik
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  BEANZVISION 29 Jan  (5 of 5) 
11915.5 In reply to 11915.4 
Thanks Mik, I'll check it out! :)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All