Hello
I am playing with lightburn software..which is a laser cutting software.
but the only reason I bought it so I can basically have a huge "scanner"

One of the features is tracing...so if I have a picture it can trace it, I export as dxf to Moi and edit if needed.
Attached is a trace that it did and send to Moi.

Is there a way for the lines to be devided into constant point with equal distance to smooth it out even more?
tnx!

Hi Matadem,

re:
> Is there a way for the lines to be devided into constant point with equal distance to smooth it out even more?
> tnx!

Are you talking about the lines that are being generated by the lightburn software?

Maybe I'm not understanding properly but if there is a way to do that it would be by an option inside the lightburn software that is generating the lines, not inside MOI where it is importing the already created lines...

- Michael

Rebuild (bottom page)
then ReconstructCurve ? (top page)


You will have just "2 corner points" to resolve! :)

Or seems there is also something to make a curve from Points of Control points... I don't remember :(
change Control Points to Points then make curve from simple points :)

You can also Transform /Array / a Point to the original curve then make the curve by these arrayed points! ;)

It may be easier to just use the import as a base and then redraw it like this.

Tnx the reconstruct curve seems good.

The tracing works good ....I just want to make it a bit better.

I use https://svgtrace.com/png-to-svg for tracing and then rebuild command if it's necessary.

Mik