Deviations between drawing and measured length

Next
 From:  tramfreak (IBBA) 9 Aug 2025  (1 of 3) 
11779.1 
Why is there this difference between the drawn and measured (displayed) length?

Bodo-Lutz
Attachments:
Attachmentroofs.3dm
Attachmentroofs.docx
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson 9 Aug 2025  (2 of 3) 
11779.2 In reply to 11779.1 
Hi Bodo-Lutz, it's because the rectangle isn't a true rectangle. It's either rotated or skewed a little so it's more like a trapezoid.

If you draw a new rectangle from corner to corner on top of it you should see it is different:





- Michael
Attachments:
Attachmentskewed1.png
Attachmentskewed2.png
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  tramfreak (IBBA) 9 Aug 2025  (3 of 3) 
11779.3 In reply to 11779.2 
Thank you Michael and sorry, this was not visible without zoom.
Have a nice weekend!
Bodo-Lutz
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All