Hi!

I'm looking to make the circled portion a smaller radius than it's opposing side. How would I achieve that?

Also, are there any kind of Udemy courses on for this software? I really want to master it, but I haven't found a good, consistent series (there are good portions of series out there, however).

Thanks!

Hi,

We have many possibilities to do it.
The basic is filleting with use of Fillet set, but My advaice is to read documentation on this or consult a tuto because it's not easy when you do it for the first time.
You could use loft with 2 different profiles.
Sweep is also possible.

To find tutorials and courses, you can consult the ressource section in this website.
Many, are great for new users, some are more advanced.

Have a good modeling with MoI3D !

Hi Brent,

re:
> Also, are there any kind of Udemy courses on for this software?

There are a couple on Gumroad:
https://kotur.gumroad.com/l/vavRq
https://gumroad.com/l/fGqqS

- Michael

Hi Brendt, and for this part:

> I'm looking to make the circled portion a smaller radius than it's opposing side.
> How would I achieve that?

That can be done using a "variable radius fillet" which you can activate inside the Fillet command by expanding the "Fillet set" section in the Fillet options and clicking "New point set". That will allow you to pick a point and set a separate radius to be used for that point.

There is an example video on YouTube here:
http://www.youtube.com/watch?v=CemIL-wleOw

- Michael

Thank you Michael! Very helpful as always!